Immersion Submersible Waterproof Electric Heating Tube with Wire 380V 6KW
Detailed Description
I. Overview of Immersion Submersible Waterproof Electric Heating Tube with Wire 380V 6KW:
Use of Sheathed Tubular Electric Heater for Wind Power: Used for heating hydraulic and lubricating oil in hydraulic and lubrication devices, also can be used to heat non-corrosive gas or liquid
II. Technical Parameters of Sheathed Tubular Electric Heater for Wind Power:
Rated Voltage: Single-phase 220V, Three-phase 380V
Surface Heating Power: As far as possible ≤0.7/cm2 as design standard
Heat Transfer Temperature: ≤300℃ Working Medium: Mineral
Working Pressure: ≤0.8Mpa
III. Structure of Immersion Submersible Waterproof Electric Heating Tube with Wire 380V 6KW:
1. This electric heater consists of a heating core and a protective tube. The heating core uses tubular electric heating elements as the heat source. The protective tube is made of thin stainless steel, which has a large heat dissipation area and fast heat transfer. The terminal part is divided into ordinary type (using iron-made stretched cup-shaped shell) and special type (using bolted explosion-proof device shell sealing). The special type meets the requirements of explosion-proof mark dIICT4 and protection level IP65 series standards.
2. The electric heater is connected to the oil tank container body by flange, isolating the heating core from the heated oil. When repairing the electric heater, it is not necessary to drain the oil in the tank. For SRY6-4|SRY6-5|SRY6-6 sheathed electric heater, only need to pull out the heating core and replace it with a new one, convenient maintenance.
3. During design, the contact area between the protective tube and the heated oil should be considered to prevent local carbonization of the oil due to excessive heating temperature. This model of heater is only suitable for heating heat transfer oil or oil with good heat transfer effect and medium internal heating.
IV. Functional Features of Sheathed Tubular Electric Heater for Wind Power:
1. Small size, high power: The heater mainly uses clustered tubular electric heating elements.
2. Fast thermal response, high temperature control accuracy, high comprehensive thermal efficiency.
3. High heating temperature: The heater design **maximum working temperature can reach 850℃.
4. Uniform medium outlet temperature, high temperature control accuracy.
5. Wide application range, strong adaptability: The heater can be used in explosion-proof or ordinary occasions, explosion-proof grade up to dⅡB and C, pressure resistance up to 20MPa.
6. Long life, high reliability: The heater is made of special electric heating materials, designed with low surface power load, and adopts multiple protections, greatly increasing the safety and service life of the electric heater.
7. Fully automatic control: According to requirements, through the heater circuit design, automatic control of parameters such as outlet temperature, flow, pressure can be easily achieved, and can be networked with computers.
8. Significant energy-saving effect, almost all the heat generated by electric energy is transferred to the heating medium.
V. Model and Specification SRY6-5
Voltage/Power Surface Power of Electric Tube cm2 Surface Power of Protective Tube cm2 L (mm) L1 (mm)
220V/2KW 0.84 0.7 1050 900
220V/3KW 0.84 0.7 1400 1250
220V/4KW 0.84 0.7 1800 1650
220V/5KW 0.84 0.7 2200 2050 
